Where do I find the written instructions on fitting the inner roller races of ET92 to each side of the flywheels main shafts?
I have a 0.033"shim ready for the drive side to center the flywheel/rods.
I would like to review any written instructions on this.
heat em up with heat gun and pound in place?
Timing side - have the OP31 worm, a dummy inner race ET94, pinion gear, and E80 nut to keep the hot ET92 bearing up against fly wheel while cooling.
Maybe similar pieces for drive side while bearing cools?
I have a 0.033"shim ready for the drive side to center the flywheel/rods.
I would like to review any written instructions on this.
heat em up with heat gun and pound in place?
Timing side - have the OP31 worm, a dummy inner race ET94, pinion gear, and E80 nut to keep the hot ET92 bearing up against fly wheel while cooling.
Maybe similar pieces for drive side while bearing cools?
Last edited: