PT: Exhaust Flaring Tool

[stumpy lord]

see forty years on page 299 item131 from mph 436 by dave hills for a drawing , and instructions of how to re flange an exhaust pipe.

 

[stu spalding]

An alternative is to cut a 1/8" length of thick wall tubing that push fits over the pipe and run a bead of weld round the end. Cheers, Stu.

 

[clevtrev]

If you want to use those old spare parts up, use the spacer ring out of the original big end, and weld that on.

 

[vibrac]

An alternative is to cut a 1/8" length of thick wall tubing that push fits over the pipe and run a bead of weld round the end. Cheers, Stu.

Welcome to the non standard club stu !

 

[Martyn Goodwin]

see forty years on page 299 item131 from mph 436 by dave hills for a drawing , and instructions of how to re flange an exhaust pipe.

Oh.. you mean this?

 

[stu spalding]

Been a member for years!

 

[robmfj]

Languishing in the back of the shed I have an exhaust that came in 3 sections. Front and rear down pipes and bottom pipe with "Y". I'm fairly certain this came from Ron Kemp with both down pipes ready flared. Wouldn't this be another way of cracking the nut problem?

 

[Bill Thomas]

I don't think that would look as nice ?, + There is a lot of strength with the standard setup, Not likely to fall off.
Cheers Bill.