I am having a problem aligning the dynamo sprocket with primary drive chain. The issue seems to be that the PD16 dynamo boss does not seem to go far enough onto the taper even when tightened with the nut.
The result being the nut can not be fully threaded and the boss protrudes to far into the primary drive for the dynamo drive sprocket to line up with the centre of the primary drive chain.
Bike is an early B with a 3.1/2" miller dynamo.
Struggling to find a solution, I am looking to gain about 1/16 - 1/8" to be able to line up the drive sprocket.
The result being the nut can not be fully threaded and the boss protrudes to far into the primary drive for the dynamo drive sprocket to line up with the centre of the primary drive chain.
Bike is an early B with a 3.1/2" miller dynamo.
Struggling to find a solution, I am looking to gain about 1/16 - 1/8" to be able to line up the drive sprocket.