Are you sure the G 4 shaft is fully home against the bearing race........that amount of end float seems excessive. Check the G 20 washer is 56 thou thick, give or take.
I measured the free play while holding the G19 hard against its boss on the G4 by hand, and then using a feeler gauge between the gear and G19, using the feeler gauge to push the G12 gear towards the G20/2 and its boss on the G4. Both the G19 and G20/2 are new from Maughan. I’ll measure the G20/2 later.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.