• Welcome to the website of the Vincent H.R.D. Owners Club.

    Should you have any questions relating to the Vincent H.R.D. Owners Club, or Vincent H.R.D. motorcycles in general, please contact Graham Smith, Hon. Editor and Webmaster by calling 07977 001 025 or please CLICK HERE.

    You are unrecognised, and therefore, only have VERY restricted access to the many features of this website.

    If you have previously registered to use this forum, you should log in now. CLICK HERE.

    If you have never registered to use this website before, please CLICK HERE.

Removing adaptor from industrial engine


Martin R

New Website User
VOC Member
Hello,
Does anyone have any idea how this adaptor is removed please?
Thanks in advance, Martin.
DSC00006.JPGDSC00007.JPGDSC00010.JPGDSC00018.JPGDSC00022.JPG
 

A_HRD

Well Known and Active Website User
VOC Member
Martin,
I have no idea. But I wonder if you start by undoing the 4 x slotted cheesehead screws (you'll need to fabricate a "wonky screwdriver") things might become clearer????
Peter B
 

nkt267

Well Known and Active Website User
VOC Member
Looking at the diameter of the shafts in the 4th picture from the left above it seems that the lefthand end is smaller than the righthand end.if the pin was drilled/punched out maybe the shaft with the collar on would slide off..
 

Top