I am sharing my design, not saying it is exact! Just a suggestion. I have been looking for the proper shape/design of the Round Miller early stop light switch mounting
bracket. I have looked at several pictures of early bikes, original and restored. I found it difficult to determine exact design, as view is blocked by the switch. So here is what I came up with. 3/4" by 1/8" aluminum flat bar Approximately 2 3/8" long (I made it a bit longer as my bike had a rear fender brace added, and I felt switch bracket would have to be tilted a bit forward to clear brace) I also added two washers for spacing bracket out slightly to clear the round area of the added fender brace ( See rough diagram, and pictures)
bracket. I have looked at several pictures of early bikes, original and restored. I found it difficult to determine exact design, as view is blocked by the switch. So here is what I came up with. 3/4" by 1/8" aluminum flat bar Approximately 2 3/8" long (I made it a bit longer as my bike had a rear fender brace added, and I felt switch bracket would have to be tilted a bit forward to clear brace) I also added two washers for spacing bracket out slightly to clear the round area of the added fender brace ( See rough diagram, and pictures)
Attachments
-
thumbnail_IMG_7153.jpg79.1 KB · Views: 27
-
thumbnail_IMG_7161.jpg62.3 KB · Views: 27
-
thumbnail_IMG_7155.jpg63.3 KB · Views: 26
-
thumbnail_IMG_7159.jpg40.9 KB · Views: 26
-
thumbnail_IMG_7158.jpg37.6 KB · Views: 27
-
thumbnail_IMG_7156.jpg82.1 KB · Views: 28
-
thumbnail_IMG_7154.jpg60.1 KB · Views: 27