The Spares Company
Club Shop/Regalia
Parent Website
Contact Officials
Machine Registrar
Club Secretary
Membership Secretaries
MPH Editor and Forum Administrator.
Section Newsletters
Technical Databases
Photos
Home
What's new
Latest activity
Forums
New posts
What's new
New posts
Latest activity
Information
Bike Modifications
Machine Data Services
Manufacturers Manuals
Spare Parts Listings
Technical Diagrams
Whitakerpedia (Vincent Wiki)
The Club
MPH Material Archive
Flogger's Corner
Obituaries
VOC Sections
Local Sections
Local Section Newsletters
Miscellaneous
Club Assets
Club History
Club Rules
Machine Data Services
Meeting Documents
Miscellaneous
Essential Reading
Magazine/Newspaper Articles/Letters
Adverts and Sales Brochures
The Mighty Garage Videos
Bikes For Sale (Spares Company)
Log in
Register
What's new
New posts
Menu
Log in
Register
Install the app
Install
Home
Forums
Forums: Public Access
Tech. Advice: Series 'B' / 'C' 500cc/1000cc Bikes
Comet Mongrel
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Cyborg" data-source="post: 89191" data-attributes="member: 3426"><p>Must say I had some fun getting the timing side case halve to slide into place. The ET93 C3 outer race didn't want to slide over the rollers. I ended up taking some high strength thread and winding it around the rollers a few times to hold them in against the inner race. Ran both ends of the thread out and down through the small end of the rod and gave it a bit of tension. Slid the case on so the rollers were just engaged in the outer race and then pulled on the thread to remove it. The thread was the same length as when I started so nothing left floating around in there. Can't say I've had to do that before, but there wasn't much of a bevel on the edge of the outer race compared to others.</p></blockquote><p></p>
[QUOTE="Cyborg, post: 89191, member: 3426"] Must say I had some fun getting the timing side case halve to slide into place. The ET93 C3 outer race didn't want to slide over the rollers. I ended up taking some high strength thread and winding it around the rollers a few times to hold them in against the inner race. Ran both ends of the thread out and down through the small end of the rod and gave it a bit of tension. Slid the case on so the rollers were just engaged in the outer race and then pulled on the thread to remove it. The thread was the same length as when I started so nothing left floating around in there. Can't say I've had to do that before, but there wasn't much of a bevel on the edge of the outer race compared to others. [/QUOTE]
Insert quotes…
Verification
What was Mr Vincent's Christian Name?
Post reply
Home
Forums
Forums: Public Access
Tech. Advice: Series 'B' / 'C' 500cc/1000cc Bikes
Comet Mongrel
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top